Question - come to me wont work (1 Viewer)

[NateVan]

my come to me button stopped working

 

[Sic]

my come to me button stopped working

come to me is from !mq2groupinfo, but it uses dannet by default. likely you need to ensure your !mq2dannet is working
>>> Check this post for dannet <<<

hit that link for help with dannet - folks often end up having something happen with their device or with their vpn that requires them to take a look at it

 

[NateVan]

it was working and then it stopped after an update

 

[Sic]

it was working and then it stopped after an update

so did you just do the thing that i shared?

yes. this happens with folks. something on their pc changed and they need to reconfigure their dannet or their vpn

 

[NateVan]

so did you just do the thing that i shared?

yes. this happens with folks. something on their pc changed and they need to reconfigure their dannet or their vpn

so i did all that in the link and the part where i use the group command only my main does it. toons are all on same computer

 

[Sic]

so i did all that in the link and the part where i use the group command only my main does it. toons are all on same computer

so you did all that?

if you do a /dg all /sit they all do something?

because if they're not all doign something, then there's an issue with your dannet that needs to be resolved.

are you using a vpn? if so, do you have it turned on for local traffic? some vpns dont have this

 

[NateVan]

so you did all that?

if you do a /dg all /sit they all do something?

because if they're not all doign something, then there's an issue with your dannet that needs to be resolved.

are you using a vpn? if so, do you have it turned on for local traffic? some vpns dont have this

no vpn and yes just my main is sitting the others do nothing. on the others i can right click them and click move to my main and the run to my main

 

[Sic]

no vpn and yes just my main is sitting the others do nothing. on the others i can right click them and click move to my main and the run to my main

If you mouseover your come to me button, what does it show?

If it shows something like /dgge it is using dannet, if it is something like /bcg it is using eqbc

At this point we can see your dannet isn't working, and if your come to me is set to use dannet (which is the default), you'll have to remove the dannet issue

 

[NateVan]

If you mouseover your come to me button, what does it show?

If it shows something like /dgge it is using dannet, if it is something like /bcg it is using eqbc

At this point we can see your dannet isn't working, and if your come to me is set to use dannet (which is the default), you'll have to remove the dannet issue

/dgge /nav id ${me.id}

 

[NateVan]

i un installed everything and reinstalled. fixed it.

 

[Sic]

i un installed everything and reinstalled. fixed it.

That's not really a thing other than it changing your dannet settings to default.

Following the link I had shared to completion would have done similar.

Glad you're working again.