Thanks for the reply Sic. I'm familiar with the command/broadcast, but prefer to see the settings and manually click on some characters and look at their settings using the plugin interface. Figured I would check and see if it could just start there so I don't have to manually change it on them. But its not possible so no worries and its a very minor and ocd thing anyways. Thanks again.
-
You've discovered RedGuides, an EverQuest multi-boxing and scripting community 🧙♀️⚙️. We want you to play several EQ characters at once, come join us and say hello! 👋
- Thread starter ChatWithThisName
- Start date
If you were so bored that you had nothing to do and wanted to not have this, you could just block the buff it gives you and we wouldn't try and use it
Question for TLP use, when fighting fear dragons with my small man my monks often get stuck after a fear trying to path back as it seems to not use mq2nav when tracking back to the ma target and just runs into a tree or wall until I manually tab over to them and try to fix. Any suggestions or workarounds for this? It makes 6 boxing really difficult when all my guys are all getting stuck every 10 seconds.
Thanks in advance!
Thanks in advance!
we only use nav to navigate to mobs- however you might be sticking too early
I'm not sure this is *really* a cwtn plugin question, as you'd likely run into similar things with other automations
without knowing the spot personally i'd just suggest the same that applies broadly across the game (not just tlp)
- MQ2FearRunner (i've never used this personally)
- stick usage
- editing your mesh to "avoid" areas
- utilize mq2autosize for places that might get you stuck on something a smol toon can go under or a larger model can go over
- shrink if you're not autosizing
- utilize "come to me" or other
/dgze /nav if ${Me.ID}