Question - INI kissassist being overwritten

[carpunky]

Hi

I was trying to setup kissassist, been using IHC.....I searched for some level 30 cleric kiss ini files

I found some and replaced with my cleric ini file........I load the kissassist with my cleric and it seems to revert back to the old ini file
which , i find weird, because i overwrite that file......I know this because i open the file and it looks like the original

i will close evrything and do not load kissassist and go back and check the ini file, it is intact as the new one, but as soon as i start kissassist , it reverts back to the old file

any clue

 

[Sic]

Are you sure u dont have mq2 installed in 2 places? Check your launcher to see where it is pointing compared to where you are editinf

 

[carpunky]

its the same file , same dir....i will change it, save it, close it, open it, to make sure ...it is the new ini still...then launch , and the exact one that i opened before has reverted back to the old ini
I even got out of my quick access folder , to double check;;;lo
Im sure it is something silly that i am doing, but i have checked this file 10 times at least

 

[carpunky]

i just put chase on the original file and it worked......so i know that i am pasting over the correct ini file
i pasted the new ini and reverted back to original with chase off ( as it was before )

 

[carpunky]

[KissError]
LastCMD:=/endmacro
ErrorDateTime:=06/16/2020 18:56:06
ErrorMsg:=DoCommand - Couldn't parse '/melee aggro=0'
DataError:=NULL
SyntaxError:=NULL
RunningTime:=1323126
BuildDate:=20200615
CurrentUI:=Default

 

[Sic]

just so we're on the same page.

after you make adjustments and saving your file, are you restarting your macro?

 

[carpunky]

yes

 

[Cannonballdex]

I know this happens when altering files that come with the updater. If you edit files then update, it will overwrite all the files included with the updater.

 

[Allurex]

So a work around this is to use mule assist.. load in ur ini.s then save over it