• You've discovered RedGuides, an EverQuest multi-boxing and scripting community 🧙‍♀️⚙️. We want you to play several EQ characters at once, come join us and say hello! 👋

  • A TLP without truebox has thawed (Very Vanilla ready)
    Frostreaver

Problem - Failing to Pull Certain Mobs

yangwenlii

Active member
Joined
Oct 31, 2020
RedCents
271¢
I've been having some issues with my pullertank randomly adding mobs to the ignore pull list before tagging them and then those mobs get skipped and don't get pulled. Any idea what would be causing this?
 
Sorry. Using KA 12.

This is the pull section of my ini

INI:
[Pull]
PullWith=Protest for Power
PullMeleeStick=0
MaxRadius=900
MaxZRange=75
UseWayPointZ=0
PullWait=4
PullRadiusToUse=100
PullRoleToggle=0
ChainPull=0
ChainPullHP=30
PullPause=120|2
PullLevel=0|0
PullArcWidth=0
PullOnReturn=1
 
There are a couple of reasons mobs get added to the ignore list. The biggest reason is that the mob vas validated as pullable before starting the run to pull. Somewhere between taking off after the mob and getting to the mob. The mob was no longer a valid pull target. This happens more to wandering mobs than stationary. The Ignore list is cleared every 5 minutes, so the puller will try again, but you have to wait.
 
Bumping this because I have seen this on two chars since KA12. Mobs that are in range and the right level etc and the puller will cycle through targeting them and then add them to the ignore list. They aren't moving or anything. He doesn't start to attempt to pull them. When I pause the macro to check on them all the mobs have good Navs. In any given camp he seems to ignore about half the mobs. I saw that the ignore list is cleared every 5 minutes and he will attempt to pull them again and sometimes it works with no changes.
 
Running into this as well. Oddly it happens with certain toons set as puller and not others.
I figured it out!! I was using my warrior to pull and having him use berate. If berate is on cooldown when he goes to pull it flags it as unpullable and ignores it. I switched to melee and haven't had an ignored mob since. I am not sure why it was happening on the bard though as he was set to melee. Maybe if he was casting a song it did the same thing?
 
I figured it out!! I was using my warrior to pull and having him use berate. If berate is on cooldown when he goes to pull it flags it as unpullable and ignores it. I switched to melee and haven't had an ignored mob since. I am not sure why it was happening on the bard though as he was set to melee. Maybe if he was casting a song it did the same thing?
bards should be pulling with Sonic Disturbance AA (12s refresh). Warriors can use archery to pull and there are summon arrows clickies available so you don't run out of arrows.
 
I'm using a Monk to pull with Distant Strike, and it's never on cooldown when he goes to pull, but this still happens sometimes. Any other thoughts?

All the mobs are static, so it's not a wandering issue. Other times they'll be pulled no prob.
 
Problem - Failing to Pull Certain Mobs

Users who are viewing this thread

Back
Top
Cart