- Joined
- Dec 1, 2016
- RedCents
- 419¢
When i run kissassist in hunter mode, my tank will target a mob, say he's pulling it, then do backwards/sideways laps around the room he's in. If i start the same mac in pullertank mode he'll run on to the mob no problem with nav, but he's in a low level TS material farming situation, i really would like him to just wander the zone killing everything thats breathing rather than wasting half his time running back to camp.
I have the nav mesh built, if i put him in hunter mode and then type "/nav target" he'll go right to it (the mob kiss already has him targetting and claiming he's pulling) and get to killin everytime. I've been trying to find where in the kissassist mac it declares pulling, and try to insert my own /nav target (if i can find that line, i'm no programmer at all. I've saved my own separate file to tinker with in this fashion incase i screw something up)
I will still be tinkering with it to try to find where to insert /nav target, but would sure appreciate if someone could even just give me a line number or something to narrow down my search. I know how to work the nav mesh, and in any /kissassist puller situation i've figured things out and got it going. In this case i simply believe it to be whatever pull command is being issued with hunter active.
This problem has happen both pre and post update, i already know you're going to ask me if i've updated, and yes. Also ran the patcher just this morning to make absolutely sure.
Thanks in advance guys, i usually try to sort this stuff out on my own, but this one so far has been beyond what i've learned on here thus far.
I have the nav mesh built, if i put him in hunter mode and then type "/nav target" he'll go right to it (the mob kiss already has him targetting and claiming he's pulling) and get to killin everytime. I've been trying to find where in the kissassist mac it declares pulling, and try to insert my own /nav target (if i can find that line, i'm no programmer at all. I've saved my own separate file to tinker with in this fashion incase i screw something up)
I will still be tinkering with it to try to find where to insert /nav target, but would sure appreciate if someone could even just give me a line number or something to narrow down my search. I know how to work the nav mesh, and in any /kissassist puller situation i've figured things out and got it going. In this case i simply believe it to be whatever pull command is being issued with hunter active.
This problem has happen both pre and post update, i already know you're going to ask me if i've updated, and yes. Also ran the patcher just this morning to make absolutely sure.
Thanks in advance guys, i usually try to sort this stuff out on my own, but this one so far has been beyond what i've learned on here thus far.
