Question - Pullertank Question about not moving.

[zorg]

Version of KissAssist.mac?

12.002

When did your problem start?

Not a problem just curious if it's possible to lock tank in a specific place while pulling.

Character Role?

1. Tank

What class is having this issue?

1. Warrior

How often does this issue occur?

Always

This probably isn't possible but I'm curious if I can set the pullertank to be rooted to the spot they pull from and not move?

I did try to reduce my camp size down to 5 but he still runs to them. They are approximately 60-100 feet away. I also tried to remove battle leap incase it was causing him to jump to them but he just literally doesn't use the bow most of the time and runs to them.

I have 4 caster mobs and I'm trying to keep my tank in the middle of a room but as he's pulling they start casting and he runs right to them. I want him to wait on them and make them come to him.

This is my pull section

[CODE title="PUller"][Pull]
PullWith=Phantasmal Luclinite Riding Bow|Ethereal Arrow
PullMeleeStick=1
MaxRadius=150
MaxZRange=5
UseWayPointZ=1
PullWait=18
PullRadiusToUse=100
ChainPull=0
ChainPullHP=90
PullLevel=1|0
PullPause=45|2
PullRoleToggle=0
PullArcWidth=0
PullOnReturn=0[/CODE]

Any advice would be appreciated but I have a feeling this might not be possible.

Thanks a ton in advance.

 

[Leo]

You can accomplish this by adjusting your meleedistance in the melee section. Try reducing it to like 20 or 25. Then your tank will pull and return to camp and will not run out to engage the mob until it is within that meleedistance range. Just be careful and make sure you adjust the meleedistance of all of your other toons as well so you dont end up with other toons dpsing with the tank standing there.

 

[zorg]

Thanks, this worked perfectly. I had it set at 75 so that was quite a bit more than it should have been.