Ok so after weeks of seamlessly no help at all - I spent a few hours tracking down a dev from macroquest2.com to speak with them a few hours about something with
mq2moveutils.ini and me complaining and crying cause something was broken that needed to me addressed or fixed with the plugin- and getting no help or lack of help have found and got the solution fixed and my snaproll back to camp is now working again -
OK so im not sure whom uses wineq2 besides me - but it can effect a lot of crap within
mq2moveutils and I didn't know that until recently where wineq2=off was added to this plugin - has redguides compile has not had that within the plugin the 5 years ive been here on this website and now it is - will not mention whom I spoke to but was not from here wineq2=off got added to the plugin a few patches back...
so if your a whinny baby like me and want this plugin to work right for your heading and turnrate and you use wineq2 this is what you do
go to your macroquest folder and search for
open it up then go down to
[Defaults]
AutoPause=on
BreakOnWarp=on
BreakDist=250.0
BreakOnGate=on
Verbosity=off
stuckDist=0.3
turnDirection=-10.0
stuckCheck=5
StuckLogic=on
LeashLength=100.0
CampRadius=25.0
MinDelay=3000
MaxDelay=8000
AllowMove=32.00
AutoPauseMsg=off
AutoSave=on
AutoUW=off
BreakKeyboard=on
BreakMouse=off
BreakOnGM=on
BreakOnSummon=off
DistSummon=8.00
FeignSupport=off
Heading=true
HideHelp=off
KeyboardPause=off
MousePause=off
LockPause=off
PauseMinDelay=500
PauseMaxDelay=5000
SaveByChar=on
TurnRate=100.00
UseWindow=off
FullVerbosity=off
TotalSilence=on
VerbosityFlags=0
WinEQ=on <----------------------MAKE SURE THIS IS TURNED ON FOR WINEQ2 use other wise this plugin will not work correctly