Hey guys, I'm a n00b and i'm sure these questions have been asked 100 times. I tried searching but just couldnt find the answer. So i have a zerker loaded up and am using MQ2Berserker. Whenever I load him into the guild lobby he continues to want to run right back to a default location with MQNAV. How do I get him to stop running back to the same spot? Second question is when I load up kissassist it gives me a message saying Auto Attack on Assist is now OFF. I want autoattack to remain on during assist. How do I change that?
-
You've discovered RedGuides, an EverQuest multi-boxing and scripting community 🧙♀️⚙️. We want you to play several EQ characters at once, come join us and say hello! 👋
Question - MQ2Berserker and Kissassist
- Thread starter DreddOwns
- Start date
The running back to a spot is because he was logged out in /zerk assist mode. do /zerk mode manual and he'll stop doing that. Or /zerk mode chase if you have a main assist in the group with him, and he'll auto-follow them.
the attack on/off issue you can ignore, he will still assist just fine. both the plugin and the macro functions by default will turn attack on when you have a mob to attack.
-And to appease Sic and CTWN: KA is not at all required to be run with the zerk plugin. It's dps and most other functionality will work without any macro such as KA loaded. In addition, KA can potentially conflict with the plugin if both are run at the same time, and is not recommended if you are new to using plugins and macros, as you must disable certain functions within KA in order to alleviate the conflicts.
the attack on/off issue you can ignore, he will still assist just fine. both the plugin and the macro functions by default will turn attack on when you have a mob to attack.
-And to appease Sic and CTWN: KA is not at all required to be run with the zerk plugin. It's dps and most other functionality will work without any macro such as KA loaded. In addition, KA can potentially conflict with the plugin if both are run at the same time, and is not recommended if you are new to using plugins and macros, as you must disable certain functions within KA in order to alleviate the conflicts.
using the modes appropriately there isn't much reason to use kissassist (outside of out of group assisting), and it isn't recommended/supported.
- Joined
- Dec 29, 2017
- RedCents
- 24,133¢
If you're wanting to use snare then you would need to handle that in another way. However, I must say that using KA is a bit overkill just to hit a snare. This is something that can be accomplished with about 3 lines of code where-as Kissassist is in the neighborhood of 10-15 thousand lines of code.
Many_Whelps
WoW was the first MMO
- Joined
- Jul 22, 2018
- RedCents
- 772¢
You'd probably be able to set something up in mq2react plugin to handle snare.