Question - MQ Pause

[Jojobeans]

Have an issue with group pausing.

What has been happening to me is my group will be fighting for awhile. I control the tank. Then I will agro a mob and then notice no one is helping including my cleric who stops healing.
Looking at the at MQ window I notice that all the toons have /mqpaused. As far as I no I have not hit a group pause button (that I made).

I can hit my pause button the get them going again but that assumes I see it has happened and that I am still alive.

What would cause a pause without me tell it to pause?

 

[wymranar]

Have you considered a ghost?

 

[PGrimes]

Funny, I have seen my tank getting unpaused out of the blue.

 

[synicasm]

/mqpause is a toggle is it possible one of your sessions become out of sync with the others in regards to their pause state ?

Char 1 /mqpause (status off)
Char 2 /mqpause (status on)

Enter global /mqpause

Char 1 becomes (Status on)
Char 2 becomes (Status off)

 

[Jojobeans]

I've not seen them get out of sync. They are status on then all of a sudden status off with no command from myself (that I am aware of). From what I see in the MQ window.

I have a global "pause" button set up but I rarely use it.

Could lag cause anything like this?

 

[Knightly]

Unlikely to be lag. It’s either something you’re hitting pausing the macro, some automation pausing the macro, or there’s an error in a variable in a condition that is pausing the macro. If it’s actually paused, that is. There are a few macros that take “breaks” after certain time periods.

What macro are you using?

 

[Jojobeans]

KA VV.

It does look like a pause key is being pushed. But I don't know how. How would I see if it is an error in a variable in a condition?

 

[Robban]

KA VV.

It does look like a pause key is being pushed. But I don't know how. How would I see if it is an error in a variable in a condition?

then it should report an error on the line above "Macro is paused"