Question - Melee toon not moving into melee range...

[surfdog21]

I am finishing up a nice melee only Ranger ini...

Very recently I noticed my ranger has stopped moving into melee range..."your target is too far away, get closer'" -not sure if its because of all of the casting he does...it wasn't doing this not too long ago. Any ideas?

I want him to be as tight on the mob as possible...

MeleeDistance=

what should this be set at for that?
what should my /stick say?

 

[rainer09]

Are you wanting to range while distancing it for kicks also?

If so would need to make a min/max distance condition but i honestly dont know if you can use a condition there.

 

[surfdog21]

No, this is a melee only ini I am working on, no range at all.

 

[ctaylor22]

Do you have MQ2MeleeOn turned on?

 

[rainer09]

oh ok
Melee Distance= needs to match what your tnak melee distance is or else alittle larger.

MeleeOn=1
FaceMobOn=1
MeleeDistance=50
StickHow=!front

 

[surfdog21]

[Melee]
AssistAt=99
MeleeOn=1
FaceMobOn=1
MeleeDistance=50
StickHow=Front
AutoFireOn=0
UseMQ2Melee=1
TargetSwitchingOn=1

MeleeDistance=50

Is 50 the closest number to mob available?

 

[ctaylor22]

Here is part of your issue. If you are using MQ2Melee(UseMQ2Melee=1), then your /sticking is controlled by MQ2Melee and not KissAssist. All kiss will do is run you to the mob initially, but then releases /sticking to MQ2Melee. Make sure you have everything in MQ2Melee setup properly, for controlling your character.

 

[surfdog21]

Focused Storm of Blades/Focused Squall of Blades disc if endurance above this %

What should this command look like? Can turn stormblades on no problem /melee stormblades=1 but cant figure out how to set the percentage.

Also, after setting up MQ2Melee do I i need to restart macro for settings to take effect?\

 

[ctaylor22]

No on restarting the macro. but you do have to reload your melee settings.