Question - Map issue (1 Viewer)

[malech1983]

Hey guys, Which setting under pull allows you to change from pulling in a 360 degree circle to say a half circle? Thanks in advance!

 

[durango773]

Hey guys, Which setting under pull allows you to change from pulling in a 360 degree circle to say a half circle? Thanks in advance!

Are you not seeing your pull area on the map? map has nothing to do with your combat automation suite. To display the markings on the map, eq button, mq button, plugins, mq2map.. for the actual ACT of pulling, would need to know your automation.

PS EQ map layer settings also need to be on, otherwise its possible to turn on MQ2map settings.. but not see it in game..

 

[malech1983]

Are you not seeing your pull area on the map? map has nothing to do with your combat automation suite. To display the markings on the map, eq button, mq button, plugins, mq2map.. for the actual ACT of pulling, would need to know your automation.

PS EQ map layer settings also need to be on, otherwise its possible to turn on MQ2map settings.. but not see it in game..

 

[malech1983]

 

[durango773]

View attachment 58469

That is a MA/KA ini looks like.. PullArcWidth=90 make that 180 (half cirlce) or 270 (pac man) or 360 (full circle).. it doesnt have to be cardinal points (can do 89, 182, 275 or 359), but thats what sets your combat AUTOMATION pulls. seeing them on the map isnt part of that setting.

 

[malech1983]

That is a MA/KA ini looks like.. PullArcWidth=90 make that 180 (half cirlce) or 270 (pac man) or 360 (full circle).. it doesnt have to be cardinal points (can do 89, 182, 275 or 359), but thats what sets your combat AUTOMATION pulls. seeing them on the map isnt part of that setting.

Ty very much lad!

 

[malech1983]

Ty very much lad!

I used to play a lot and the last time I had figured out some way to show the arc on the map. It was pretty cool to be able to setup pulls in a cone in front of my puller. I just can't figure out what I had done back then to get it to show up on the in-game map. All good though ty again for the info Durango!

 

[TinyBubbles]

To make sure you can see the camp radius, pull arc, and the tanks/pullers range (with spell, bow or AA) on the map for the main tank, make sure you have layer 2 and layer 3 on. Layer 2 shows 2 of them. layer 3 shows the third. Or maybe its all on layer 2. Reguardless, check that your layer 2 and 3 are checked.

 

[malech1983]

To make sure you can see the camp radius, pull arc, and the tanks/pullers range (with spell, bow or AA) on the map for the main tank, make sure you have layer 2 and layer 3 on. Layer 2 shows 2 of them. layer 3 shows the third. Or maybe its all on layer 2. Reguardless, check that your layer 2 and 3 are checked.

Will do, Tyvm!