Question - Levitation path

[HunterX44]

Is there a way to make a bard with levitation go straight over a lake? When I edit the KA info.ini to pull a specific mob, the bard doesn't take the direct route over the water. It ends up going way out of the way and crosses at a very specific point, then comes back. Can I change something to get it to go in a straight line instead?

 

[truculent1]

Need to edit your nav mesh.

https://www.redguides.com/community/threads/meshgenerator-exe-tutorial.63553/

 

[kaen01]

nav usually follows the bottom of water areas, that is why people tend to mark those areas as avoid, also the areas can be hard to get out of with nav,, so again people mark them as avoid.

 

[HunterX44]

Thanks for the replies, I'll look into it!

 

[ctaylor22]

I have used this in the past to pull into the water, but never tried to run across the water. As long as you create a path where your puller can get in and out of the water with no problems, you should be able to do this. Just make sure your puller has max Swimming skill.