Problem - CWTN plugs resetting to mode 0 automatically?

[Myysterio]

this is more of a question, but its because of a problem and i dont know what is causing it, did a raid today and CWTN plugs were resetting to mode 0 automatically. Not exactly sure what i did to make them do this or what could cause it.

 

[Sidien]

Missing MQ2Nav mesh for the raid zone would cause this.

Try "Launch Mesh Updater" in the RedGuides launcher, and see if that helps.

 

[Sic]

this is more of a question, but its because of a problem and i dont know what is causing it, did a raid today and CWTN plugs were resetting to mode 0 automatically. Not exactly sure what i did to make them do this or what could cause it.

Please see >>> Getting Started with CWTN plugins! (Movement, UI Window, Clickies, Pulling, ETC) Check Here First! <<<

the only time we would reset to mode 0 is with no mesh. And we say that is what we are doing in the window