Problem - cant see NPC's

[reccox]

I cant see NPC's on the map I have tried /mapfilter NPC and it still dosent work what can i do different?

 

[Sic]

I cant see NPC's on the map I have tried /mapfilter NPC and it still dosent work what can i do different?

Check out what visible layers you have - off the top of my head i think npcs are layer 2

 

[Cannonballdex]

Not sure what all you have tried. I like to keep a clean map and type /mapshow named or /mapshow NPC only when I want them to show. I noticed a full map of mobs will lag out my screen when I open the map. and /mapshow reset when i want to clear the map again.

 

[reccox]

I have the correct buttons clicked but the map reset worked nicely

 

[Cannonballdex]

I have the correct buttons clicked but the map reset worked nicely

I just set mine set up opposite. I have my map set to /mapfilter npc /mapfilter pc /mapfilter familiar, (this removes these from showing on the map) this pretty much clears the map and doesn't make my ui lock up when opening the map. Then i use /mapshow named or /mapshow pc /mapshow nameofmob I want to see on map. then /mapshow reset to clear my map again. (in your case you are /mapshow reset to put the map back to how you have it set showing all) On the map I have Base 1, 2 and 3 layers selected, because i like to see all the layers on the map. Layer 2 does have the spawns listed in like SIC mentioned above.

 

[reccox]

I still cant see the NPC's in the zone I had them up once but when i zoned it all left