Recent content by TRS80

Great stuff for sure and bonus! I didn't have to write my own LOL

Ran into a nil comparison error changed lines 120 and 134 from speak.lang to speak.num If this is in error please let me know. Thank you,

Thanks, I took a look and I think this should work just fine. I'm running 3 rogues, so the melee focused ini will be great.

Not exactly what I was looking for, but thank you =)

Thanks I'll look this over and try to adapt.

Thanks, I did check before posting here.

Would anyone be willing to share their bard inis for levels 110, 115 & 120 with me please? Thank you,

@ctaylor22 is there a way to mark this thread as resolved? Also, thank you for your help, and great work resolving this issue =)

I've seen this happen on each of these spells, and on normal and named mobs in LS zones: Ravening Servant Rk. II Fusillade of Many Rk. II Chaotic Magma Rk. II Spear of Molten Dacite Rk. II I didn't take note if there were any specific mobs this was happening on, because it just seemed to be...

Understood, but the problem is that those spells do land on that mob, but are removed from rotation if/when "did not take hold" happens to be returned on the same mob where these spells have landed during the same fight. I'm not sure if it's EQ returning that message when it should be returning...

Status on mana was above threshold. I used jump to drop Endurance to 98%ish and then it registered that Endurance was above 1%, yes I set it that low. Also, this has happened multiple times.

I had to jump a few times on my healer to make it's endurance to go down below 100%. That then triggered a good condition and pulls were able to begin again.

When a spell DID NOT TAKE HOLD, kissassist was pausing the use of that spell. I'm not sure if it is considering a resist to be the same thing here. I commented "/varset DPSTimer${1} 5m" out so that the spell could continue to be cast. This was happening for the following mage spells...

Thank you. Yes it's a lot of information, but I'm going to take my time and make certain that multiboxing is exactly what I want to do.

Thank you =)