Question - Where can I add mob name that I want to pull ?

[Flexbus]

Where Should add below command ? and are there pull priority ?
Because I hope to pull ph first then anothers.

example:
[Ethernere Tainted West Karana]
MobsToPull=List up to 25 mobs. Can be partial names Macro example: rat,snake,bear or ALL for all mobs
MobsToIgnore=a spider egg sac
MobsToBurn=Grawrarawr
MezImmune=List up to 10 mobs. Use full names i.e. a green snake,a blue tiger,a wide eye ooze or NULL

 

[eqtrader74]

It's in the KissAssist_info.ini in your Macros folder. You can type the names in MobstoPull or use the "/addpull " command if you have KA running. Make sure you don't add spaces between the names, just name-comma-name-comma-name...

This example will pull the PH's and Named for a couple named at a camp in Overthere. It will also ignore a the annoying named "a majestic cockatrice" and some other traps. If there are no PH/Named up inside the PullRadius, puller will wait a certain number of seconds (PullWait) and check again. If you have BurnAllNamed=1 (all named) or BurnAllNamed=2 (burn only named listed in the info.ini) on your toons, they will activate Burn on Needle or Saber

[The Overthere]
MezImmune=List up to 10 mobs. Use full names i.e. a green snake,a blue tiger,a wide eye ooze or NULL
MobsToPull=a raging rhino,a needle-covered succulent,Needle,Saber
MobsToIgnore=a sarnak trap,a piranha,a majestic cockatrice
MobsToBurn=Needle,Saber
PullPath=Place holder for path file. Not yet impletmented.

No pull priority in default KA. KA will pull the closest matching pull mob. You can select an PullArcWidth in your pull section if you want to tighten your pull area, such as 180 degrees to only pull mobs in front of the puller.

If you want pull priority, you can check eqmule's mod of KA10. It adds an additional secondary pull list, so you can priority pull PHs or Named over trash mobs.