Problem - Unable to get burn to work on command

[bowhunter_241]

Burn will work when set to burn all named, but I cannot get it to work on command.

I am using the /bcg //Decepticons Attack command in MQ2EQBCS and the message does go through, but the following is the response the other two characters give.

#CMD: [/Decepticons Attack]
[*****(msg)] //Decepticons Attack
DoCommand - Couldn't parse '/Decepticons Attack'
kissassist.mac@3597 (CanIDoStuff): /delay 2
kissassist.mac@686 (Main): /call CanIDoStuff

The ***** is the lead characters named deleted out for obvious reasons.

All three macros show KissAssist v.8.3.0 by Maskoi at the top. I have made no modifications besides the basic addition of spells, discs and abilities in each characters macros.

First toon is run /mac kissassist manual and the other two are run with /mac kissassist. The run one on manual is where I call the command from.

Can anyone please help?

 

[winnower]

Try

/bcg //echo Decepticons Attack

http://www.redguides.com/community/showthread.php/33000-Documentation-incorrect-for-activating-bur

 

[bowhunter_241]

That did it, thank you very much.