• You've discovered RedGuides, an EverQuest multi-boxing and scripting community 🧙‍♀️⚙️. We want you to play several EQ characters at once, come join us and say hello! 👋

  • A TLP without truebox has thawed (Very Vanilla ready)
    Frostreaver
Resource icon

Release Smuggler Reports Quest 1.0

No permission to download
This is really fantastic. I went through the code to add support from a Bard & WIZ/DRU ports to Dawnshroud Peaks from the quest giver in Shadownhaven. It cuts down the turnaround time significantly.

One hang-up I'm running into is that my toons will stop just short of zoning into Nexus from Netherbian Lair. I have to monitor and tap them forward just a touch to get them to zone. Is there a code snippet we could incorporate to resolve this? Or, is it a mesh issue? I love playing with stuff like this. It's simple enough to play around with. Thanks!
 
There is a code snippet I can do to push you across the finish line. I have not had an issue with the mesh not getting me there though.
 
Ah! I think I know what it was. I had set my /nav distance too high...I had /nav setopt=15. I'm goint to try and set that to either 5 or 0 and give it another try. I didn't think about that option making it so your toon doesn't quite reach the location, but just one step away.

Confirmed: distance was set too high in MQ2Nav. ...all clear
 
Last edited:
Yes.

What I found (for my setup at my home) is that a distance of 10 worked but 15 was too much.

And just so there is no ambiguity, I use:
[CODE title="MQ2Nav Options Setting" highlight="1, 5"]/nav setopt dist=10

and

/dgga /nav setopt dist=10[/CODE]

*Note that this is almost always running with significant speed modifiers. If you move slowly (low level, no buffs, etc.) you may need to lower your distance settings because you will slow down faster and come to a smooth stop with little to no overshot of your intended destination.
 
Question: Travelto Dawnshroud

when im at the quest giver in shado haven and she gives me the report i get an error

1673240451250.png

am i doing something wrong? Thanks
 
Good evening!

I'm unable to get this running using /mac havendefender, below is the output. Any ideas?
 

Attachments

  • Screenshot 2023-01-16 053021.png
    Screenshot 2023-01-16 053021.png
    293.7 KB · Views: 3
Release Smuggler Reports Quest

Users who are viewing this thread

Back
Top
Cart