Problem - Puller/Hunter issues

[woobz]

Anyone else have an issue where your puller/hunter will run past a large number of mobs to grab one, regardless of creating a train or not?

I see Nav running for both directions, but it just appears to skip a bunch of mobs(even mobs of the same name is it currently navigating to).

 

[LegalSoldier]

Yes, this got me killed multiple times in velks. Pullers runs right through a bunch of mobs to get to one mob far away and then trains them all back to the group.

 

[Maskoi]

Check you kissassist_info.ini and make sure you don't have any mobs on ignore.
Also did you set levels for pulling in the toons ini. If too high or low it might ignore those mobs because of their level

 

[woobz]

I double checked everything, and even nuked it all and started with a fresh ini just in case. No level cap set, and no excluded mobs. I will literally have him run by "a kobold" 4 or 5 times, navigating to a further "a kobold" of the same con. Its like it is just missing the fact that there are mobs.

 

[Terit]

Send your puller portion of your INI. I'm willing to bet it's a Z radius thing, as that was my issue in the past.