Question - Pull level

[rshackleford]

Hey all, trying to slowly figure this stuff out. I noticed with KA there's a pull level parameter. With CWTN SK plugin I'm having an issue where the tank pulls mobs way too high, attempts to pull guards etc. Do I just have to manually add these nearby targets to pull ignore or is there some way to set a pull level range?

Thanks for help!

 

[( @ )( @ )]

In Kiss ini:
PullLevel=0|0

set min and max pull levels

 

[rshackleford]

Oh ok thank you for fast response.

I was under the impression that using a CWTN plugin meant not being able to use KA whatsoever for that character.

 

[( @ )( @ )]

Not sure on that plugin. I just run kiss and other helpful plugins for my situation. In theory it should work. Give it a go and see what happens

 

[Nurd6]

When I enter a new zone, I check my map and add all the NPC and high level mobs to my ignore list.

 

[Rooster]

Im not sure about pull levels, but you can do a /shd ignore with the mobs on target and it will add them to the ignore list for pulling .. they end up in PullIgnores.ini in your MQ2 release folder

to removed the, do a /shd Unignore with them on target

ie in lobby on bst I did a /bst ignore with the high priest on target, my ini now has

[GuildLobby]
Ignored=|High Priestess of Luclin|

 

[Sic]

Hey all, trying to slowly figure this stuff out. I noticed with KA there's a pull level parameter. With CWTN SK plugin I'm having an issue where the tank pulls mobs way too high, attempts to pull guards etc. Do I just have to manually add these nearby targets to pull ignore or is there some way to set a pull level range?

Thanks for help!

We'll be adding some more pulling customization here in the future like lvls, there is a semi complicated under-the-hood way to do it in its current form, but we'll be adding an option for it to make your life easier very soon.

We strongly don't recommend running another macro/plugin of similar functionality because it is impossible for us to offer support, and you end up missing out on a bunch of the functionality of what's included - however, should you decide that is what you want to do, you will want to be in mode 0, with usemq2melee=0 in that kiss ini