Question - Multiple Kissassist hunter or puller question

[redhero1000]

I want to farm some spread out lower level mobs using more than one puller to save some time, but when there is a mob on xtar from a given puller, other pullers won't pull. Is there a way to have more than one hunter or puller working at once when using kissassist in a group?

 

[B_I_G__D_A_D_D_Y]

If you're farming materials best not to group them and just run everyone in Hunter mode. But if you need kill credits then run your Puller to pull mobs on the far side of what you want so it keeps getting aggro on the mobs that are in the way (which you actually do want!). And use ChainPull settings at 90% so your Puller doesn't wait until everything is dead to run out and get more.

 

[redhero1000]

If you're farming materials best not to group them and just run everyone in Hunter mode. But if you need kill credits then run your Puller to pull mobs on the far side of what you want so it keeps getting aggro on the mobs that are in the way (which you actually do want!). And use ChainPull settings at 90% so your Puller doesn't wait until everything is dead to run out and get more.

Thanks but these solutions won't work for my case.

I want the group to remain intact for buffs and heals as needed.

Aside from that, the mobs I want to farm are not social, so pulling through other mobs is a waste of time. Chain pull only very marginally speeds things up.

 

[meepo]

Muleassist has an undocumented mass pull bind to where you can designate how many mobs you want your puller to go get. Afaik, you've gotta issue the command for each pull for it do it's thing as it's not built into the automation without doing some customization to the pull routine.

 

[redhero1000]

Muleassist has an undocumented mass pull bind to where you can designate how many mobs you want your puller to go get. Afaik, you've gotta issue the command for each pull for it do it's thing as it's not built into the automation without doing some customization to the pull routine.

Well, I peeked at the doco link and like you said, it seems undocumented and I didn't find it. I'm only wanting to do this for perhaps a month on and off, so I likely won't switch over to Muleassist. Thanks though.

 

[meepo]

Well, I peeked at the doco link and like you said, it seems undocumented and I didn't find it. I'm only wanting to do this for perhaps a month on and off, so I likely won't switch over to Muleassist. Thanks though.

Gotcha. This is the command if you change your mind -
- Added bind /masspull it;s parameters are: spell name, number of mobs to pull, min level, max level, radius
| - Example: /masspull "Burst of Flame" 7 4 8 500
| Will use Burst of Flame to pull 7 mobs between level 4-8 within a 500 ft radius and bring them back to camp.