Question - MQ2Nav - Disabling for KA - Will no longer pull

[terrietuf]

Hey Guys,

I have an issue where I believe MQ2Nav is stopping KA from pulling, my Puller will no longer run around finding mobs to pull. I know this is the issue because when i do, /echo ${Nav.PathExists[target]} it is saying False. KA seemed to be working until I updated the meshes and this is an issue because I am on a custom EMU the zone names have been changed.

I think KA will work fine if there is a way to disable MQ2Nav, Unloading it does not solve my issue.

Regards

 

[Sic]

Hey Guys,

I have an issue where I believe MQ2Nav is stopping KA from pulling, my Puller will no longer run around finding mobs to pull. I know this is the issue because when i do, /echo ${Nav.PathExists[target]} it is saying False. KA seemed to be working until I updated the meshes and this is an issue because I am on a custom EMU the zone names have been changed.

I think KA will work fine if there is a way to disable MQ2Nav, Unloading it does not solve my issue.

Regards

should consider checking your mesh and fixing your mesh.

mq2nav is a far far far superior resource than moveto

 

[terrietuf]

should consider checking your mesh and fixing your mesh.

mq2nav is a far far far superior resource than moveto

I have managed to fix the mesh and update it now I am getting an =TRUE but KA is sitting there with a Waiting 5 seconds for mobs to respawn.

 

[Sic]

I have managed to fix the mesh and update it now I am getting an =TRUE but KA is sitting there with a Waiting 5 seconds for mobs to respawn.

should consider posting in the kissassist support section with your pulling section of your ini.

many people skip over the zaxis or other settings

 

[terrietuf]

should consider posting in the kissassist support section with your pulling section of your ini.

many people skip over the zaxis or other settings

Just to confirm if I unload mq2nav it pushes KA to use /mq2moveto ?

 

[B_I_G__D_A_D_D_Y]

Without MQ2Nav the best I was able to do was LOS pulling.