My group consists of a SK/BRD/CLR/ROG. I am using my SK as a puller/tank. I am also using EQBC to issue commands to my bard for various situation pulls. What I would like to do is have my bard target what I am currently targeting so that I can then have it lull, then switch to another target that target to lull so that I can then use my SK to pull. I cannot figure out the EQBC command to do this though. This is what I have tried but it does not work.
/bct "CHARNAME" //target id ${Target}
What is the correct syntax I want to use for this to work?
Thank you in advance.
- - - Updated - - -
[edit]
The returned value i get on the bard is
"There is no spawns matching: (0-115) any"
/bct "CHARNAME" //target id ${Target}
What is the correct syntax I want to use for this to work?
Thank you in advance.
- - - Updated - - -
[edit]
The returned value i get on the bard is
"There is no spawns matching: (0-115) any"