Problem - Mesh updater Failure and trojan warning

[Hirombi]

Just installed the Red Guides Launcher. When trying to run the mesh updater, I'm getting a 404 error.





Bit Defender is also identifying a trojan in one of the Very Vanilla DLL's. Not sure if that dll being removed is causing the mesh failure or if this is a separate issue.

 

[Sic]

Hrm that is unusual - thank you for the notice i'll tag in some folks who can take a look

@Knightly @dannuic

@Redbot


Might check out > this < post about the updater --- @wired420 was doing some updates that need to get sync'd with the launcher

 

[Redbot]

Try disabling Bit Defender temporarily

 

[Knightly]

Bitdefender triggers false positives on a lot of different MQ2 components as part of it's advanced threat detection.

You can either exclude the folders from bit defender or turn off that specific component.

 

[Hirombi]

@Sic ,

The post you linked about replacing the mesh updater with the download here https://www.redguides.com/community/resources/meshupdater-mq2nav-meshes.1270/ seems to have fixed it.

 

[Redbot]

@Sic ,

The post you linked about replacing the mesh updater with the download here https://www.redguides.com/community/resources/meshupdater-mq2nav-meshes.1270/ seems to have fixed it.

You should update Very Vanilla so you can use the new meshes.