Question - MA stuck to mob

[mmango]

As of the patch on the 19th, my main tank will now follow the mob being attacked. Previously, I could control the main tank normally in terms of move left / right / back / forward. Now, the tank is 'stuck' to the mob that is targeted.

I'm manually running this tank, but, losing control of this tank is rather unfortunate.

Thanks.

 

[toadwart]

I had the same issue last night on a named. Thought it was odd, but only noticed it the single time, otherwise too busy slaughtering. Not sure what the issue is.

 

[Tobes367]

Try
/melee stickbreak=1
/melee save

 

[toadwart]

I don't think that's the issue. I already have that set, and the named was the only mob I noticed it on. I targeted it from a fair distance away because I was considering pulling it first, but when I tried to move so I could target it's friends it wouldn't let me do so. There was something else going on, as combat hadn't started yet. Once I initiated combat with the mob I was able to move freely again as normal with stickbreak set to 1.

 

[eqtrader74]

If you have Burn on, KA tanks will auto-swap to any Named in camp and you can't change targets.

Options:

• Pause KA on the tank with /mqp hotkey until you kill the other targets.
• Ran KA in manual mode (with Burn off too)
• Use deathlock's KA mod for your tank, coded to allow complete target choice
• Turn off Burn: BurnAllNamed=0 (You can add ${Target.Named} conditions checks to DPS entries and get a "burn" in [DPS] if wanted)
• Set Burn to only lock on certain named via the KissAssist_info.ini file entry for each zone: BurnAllNamed=2