Question - Enc keeps invising group while tank is pulling

[condain]

Hello everyone,

I am running a 6 box crew (War, Enc, Dru, Clr, Mag, and Wiz ALL are CWTN plugin) everything will run great until randomly the Enchanter which uses the CWTN plugin will cast the group perfected invis aa. then the warrior pulls and brings mob back but no one attacks and they watch the warrior die.

I am seeing this happen mostly while using the MQ2Grind plugin

I have done /end on all toons to ensure that no macro is doing this
I have done /Lua stop on all toons except the warrior to make sure no Lua is doing this

it is still happening.

is anyone else having this problem?
is there a plugin that might cause this that I should try disabling?

 

[hytiek]

MQ2Grind doesn't, by default, instruct your ENC to invis your group.

MQ2Grind does provide an area to configure what happens at start, pause, resume, and end. You should check the Class configuration for the Enchanter and ensure you are happy with its configuration.

If you ended everything and stopped all Lua scripts, I'm not aware of any plugin which might be invis'ing your group.

I do hope that you find what's causing the constant group invis, it sounds annoying.

 

[condain]

I reviewed the enchanter class section of mq2grind and I did not make any changes, and that is still the case, no special commands to invis everyone while idle or anything.

full disclosure, I have not let this run for a real amount of time with out the MQ2Grind plugin, and honestly while I am not ruling anything out, I don't think it is this plugin. I am worried about other plugin's that might cause or have the capability to do this.
here is a list of plugin's running

 

[Sic]

Hello everyone,

I am running a 6 box crew (War, Enc, Dru, Clr, Mag, and Wiz ALL are CWTN plugin) everything will run great until randomly the Enchanter which uses the CWTN plugin will cast the group perfected invis aa. then the warrior pulls and brings mob back but no one attacks and they watch the warrior die.

I am seeing this happen mostly while using the MQ2Grind plugin

I have done /end on all toons to ensure that no macro is doing this
I have done /lua stop on all toons except the warrior to make sure no lua is doing this

it is still happening.

is anyone else having this problem?
is there a plugin that might cause this that I should try disabling?

As mentioned, mq2enchanter doesn't automatically invis. You can trigger the invis with a hotkey and we would output it in the mq2enchanter window, but other than that, nope.

 

[Zorryn]

Are you using ISBoxer and have key mapping on? I have actually had something similar happen to me in the past. I tracked it down to accidently have Key Mapping on with ISBoxer. I use ISB for managing windows and key mapping is on by default for my character sets. I usually turn it off but sometimes turn it on to hit a button (i.e. return to camp) and then immediately turn key mapping back off. My Wizard had group invis mapped to a button I used on my tank. Another example of this problem was my bard automatically attacking a mob as I pulled it with my tank. Autoattack was mapped to 1 for Bard and when I hit 1 (pull macro) on my warrior, the bard ran to meet the mob before it got to tank.

Sorry read thread again more closely and I see its happens mostly when you use mq2grind. Not sure if you are actively driving a toon when doing so above probably does not relate.