Question - DOT casting and 2-h bash

[Paladine_PSoT]

Hello!

I've got a question, well, two of them.

1: I have a paladin that just got 2h bash. How can I effectively use this with KA7? I don't use DPS so should I set it up as a DPS with an 8 second cycle or is there a way to control which combat abilities get used?

2: I have a druid that's also 59. I'm using a 30 second timer to use an entangle clicky to keep mobs from running, but I also want to use my swarm DOTs. Is there a way to set debuffs specifically like swarm and root so that it auto-casts when they wear off or should I put both the clicky and the DOT in my DPS with a longer cycle timer?

 

[Infinite Monkeys]

MQ2Melee will do the bash for you, will probably use it without you changing anything.

Dots will be recast when they wear off as long as you don't add |Once after them in the ini.

 

[Paladine_PSoT]

So I just put the dot in the DPS section like this?

[DPS]
DPSOn=1
DPSSkip=0
DPSInterval=30
DPS1=Tanglewood Shield|90
DPS2=Drones of Doom|95

I have it in there with Just Tanglewood Shield and it casts every 30 seconds to make sure it's applied whether it's worn or not.

- - - Updated - - -

dot casting is working appropriately, finally got bash working by doing:

/melee bash=1
/melee save
/melee load

- - - Updated - - -

Another tuning question: How can I get it to not worry about my merc endurance? I'm not at a point yet where it's critical to performance so i'd like to turn it off and keep pulls coming in faster.

I plan on putting a number of my notes into guide form in a bit to contribute to the existing beginners guides.

 

[Maskoi]

GroupWatchOn=0/1/2 - Off/Entire group/Healers only - Clerics, druids and shammys. Toon will stop and med when group members get below 20 Mana/Endurance and resume when they med to 90%.