Question - City of Bronze, trying to pull through walls

[mckonz]

Title says it all. I am pulling outside trying to level some alts AA's. When mobs are cleared, the tank goes to the wall and tries to pull through the wall. Any ideas?

 

[ctaylor22]

are you using MQ2Nav?

 

[mckonz]

/plugin MQ2Nav is what I used but was not able to see how to make the mesh. Any help is appreciated. Thanks

 

[Sum1]

/plugin MQ2Nav is what I used but was not able to see how to make the mesh. Any help is appreciated. Thanks

Check out the following:
http://www.redguides.com/community/showthread.php/42249-MQ2Nav

This has some additional information:
http://www.redguides.com/community/...av-Beta-by-Brainiac-and-Donation-Kick-Starter

 

[ctaylor22]

/plugin MQ2Nav is what I used but was not able to see how to make the mesh. Any help is appreciated. Thanks

The Mesh is very important in that zone, plus you may want to relocate away from the wall or put all the alarins on your ignore list. Using MQ2Nav will try and run you around the building to the entrance to pull mobs, so be careful.

 

[mckonz]

I have the mq2nav and meshgenerator, but still can't figure out how to CREATE the mesh. What am I missing?

 

[mckonz]

/bump Any simple instructions on how to create the mesh while in the zone? Thanks

 

[Rustycat]

/bump Any simple instructions on how to create the mesh while in the zone? Thanks

Have you been able to make a mesh in any other zone and just having trouble with it working there? Or are you having issue making a mesh for any zone?

 

[mckonz]

Not able to figure out HOW to make a mesh for any zones. I read through the info but must just be dense. Lol

 

[Rustycat]

Not able to figure out HOW to make a mesh for any zones. I read through the info but must just be dense. Lol

Step one... load meshgenerator.exe
Step two... run a toon in EQ to the zone you want to make a mesh for
Step three. In meshegenerator, click File... Open Zone... and select the zone you are in with toon wanting to make a mesh for.
Step four... Look at the Build Mesh button.. if things are red around it, adjust tile size until it's no longer red. Note, smaller tile size will be more detailed however will make mesh file size larger.
Step five... Click Build Mesh and watch it run.. when it's done.. it's done.. you'll know.

That's it.