Problem - CFG files

[Scorpius]

Hi

Am trying to get .cfg files all working, but get some errors when zoning - using EMU version
On zone enter, some commands work, other don't, main one is to target a specific boss if up on entering zone, but gives error
Do command - couldn't parse /tar xxxx

If i load the .cfg with /loadcfg "zone name" when in zone it works ok - no error
note: have tried a different mq2 build, "mqemulator" and working on zone in ok,

any ideas.. tried /delay but has no effect

Thanks

 

[drawthow]

Hi

Am trying to get .cfg files all working, but get some errors when zoning - using EMU version
On zone enter, some commands work, other don't, main one is to target a specific boss if up on entering zone, but gives error
Do command - couldn't parse /tar xxxx

If i load the .cfg with /loadcfg "zone name" when in zone it works ok - no error
note: have tried a different mq2 build, "mqemulator" and working on zone in ok,

any ideas.. tried /delay but has no effect

Thanks

Have you tried the /noparse in front of the /tar xxxx? Just a guess. I have been playing around with zone files and not getting very far.

Also here is a wiki on cfg files

Introduction - MacroQuest Docs

www.macroquest2.com

 

[Scorpius]

Hi

Thanx for the tip, but alas, no change - just gives the same error in red text -( it totally ignores the /noparse
odd it works ok on zone with /loadcfg, just not when zoned in and auto loaded, its a build issue somewhere, as works fine on mqemulator build, but thats built on a much older version of mq2
some commands do work on zone in, some don't

Just will have to live without some of the .CFG features that aren't working

Thanx again