Recent content by NipBiter

Yeah I'll have to check that out, prolly better then using Notepad++. Deth24 version looked to be based off what was available in the patcher as of today so yeah it may need tweaked. I just stuck this together this afternoon.

I just came across this ButtonMaster today and I have been switching over from using basic ingame macros and hotbars to this. Very nice but I came across a use case that I wanted to do. So, I prolly wasted too much time on this when I could of just copied and pasted a buttons previous commands...

I think I might have fixed it, I had melee distance set at 75, not sure where that value came from maybe default ini or something from someone elses's ini that I built from. Camp radius is at 30 on boxes and meleedistances is 35, and on tank camp is 35 and meleedist is 35. The boxes are no...

Thanks but its at 98. :)

I have seen that also but its just not on initial. Its randomly. I am noticing it may be distance based as I started pulling with a bow. If I get too close is when it I see it happening.

I don't use MQ2Melee, that is 0 and unloaded. No loaded plugins other than default. Only lua I had running was guildclicky and did /lua stop. Still they launch themselves at targets randomly when we are not engaged and npc is at 100%.

Sadely it is still happening. It also not on every mob target. I am trying to find the pattern of how or what triggers it every time but basically sometimes I can target a quest NPC maybe 100 units away and then they go into attack mode, running to the npc. Other times I can target a kos npc...

I'll have to check if that's on but what's causing them to run to the NPC and perform the /stick and start running the KA functions? Is KA seeing that autoattack is on and thinking its time to act regardless of mob HP %? Even if assist is on, that just turns autoattack on. More or so curious...

I want them to attack on assist but assist at the correct hp % not 100%. Is that not what [Melee]AssistAt=98 is for? They will try to kill quest NPCs also. And I only have KA running. This is a new issue. I basically have been having to /mqp after each pull so I can target and pull the mobs...

I have my toons sometimes when I target a fresh npc and it is at 100% ant not engaged yet they will run and attack it. Their assist level is at 98(I dropped it down from 99, to test and they still do it.) and all the dps entries are at 98 as the highest. Any thoughts?

Yeap that will do it. Thanks.

Curious if MQ2Nav also us to automate the clicks on these painting that require a right click then select teleport or open door to lobby via dannet. The doortarget and door click don't seem to work on these. I didn't seem to find anything when I searched the forums so if this already been...

Will this code change only effect cures? I think I'd still like the interrupt check on other spells. I am having this issue on my cleric as well. Also because I'm rather new to KA, what does CastingInterruptOn actually do? I was under the impression it would try to recast if the player is...