Question - MQ2Navigation Question

[ThaShadowknight]

Ok, so i followed that nifty MQ2 Navigation for Newbies guide, and it was pretty good. On question i'm not sure how to word properly.... what are the Start and End things inside navigation? I notice after i build a zone, that there's a start and end, which when i select from 1 area to the next, highlights in yellow, missing a bunch of blue tiles. Just curious, been building a bunch of zones but i think i'm doing it wrong.

 

[calaxa]

If you are missing blue tiles, then you need to rebuild the mesh for that zone using different tile and cell sizes until the whole zone is covered.

 

[ThaShadowknight]

I think you missed my comma . The Start > to End selection inside the Navigation pane, when selecting from one area >>> to the next. Will miss blue squares when it's covering the areas from point A to point B. The whole map has blue squares. But when using Start and End (selection tools inside the navigation pane when you left click, and shift left click) it only selects a limited area.

 

[calaxa]

Don't know but if you figure it out, please post back here. I gave up playing with MQ2Nav awhile back.

 

[Maxranor]

After you build a mesh, the start and end are tools to test the mesh as far as I can tell. On the right, select the Show Tools radio button, and you'll see a selection of available tools. For the default start and end tool, I think it's just checking whether the two points are connected, and the highlighted tiles are the path connecting them.