-
You've discovered RedGuides, an EverQuest multi-boxing and scripting community 🧙♀️⚙️. We want you to play several EQ characters at once, come join us and say hello! 👋
Problem - MQ2 Toons Not Loading Spells
- Thread starter Medicman
- Start date
- Status
what mq2 toons?
cwtn plugins?
kissassist?
muleassist?
I'm assuming you mean cwtn toons - but you didn't post in the any section or mention what specifically so its hard to guess.
the cwtn toons will memorize their spells if they're:
not in byos,
not invisible (unless they have a camp set),
not moving,
not paused,
not casting,
not dead,
don't have mobs on xtarget
I would start there.
if it is for kissassist then you need to ensure your ini is populated and you have LoadSpellSet set accordingly with your spells listed
Since I know you have all the cwtn plugins, I'm going to just assume you're asking a cwtn question and move this to the cwtn section. Please try and post questions to their appropriate areas so people don't have to guess what you're asking about, and so folks can better help answer your questions.
well i listed a bunch of reasons that would make you not memorize your spells, did you check any of the others or just the byos?
They are doing none of the above. I have restarted Launcher and MQ2 twice and then reloaded the toons, /bccmd connect on all, created the group, and they will not load spells. NEVER, had this issue every before so I am at a loss. Thanks for your help and I will be more careful in the future where I post.
it is veryunlikely that restarting your launcher, or re-downloading a file you already have would change anything.
We also don't care about eqbc/dannet for spell memorizing purposes (the *only* thing that gets broadcasted is mezzing).
Considering this is across the entire swathe of toons you have, I would strongly suggest double / triple checking the invis part. since it is more likely that you logged out with everyone invis than changing everyone to byos on
I would normally suggest reloading your UI in case your xtarget is bugged and mq2 thinks you have mobs on xtarget but dont - however you said you restarted already so I'm not going to suggest that.
also curious what state you found yourself in that you think that none of your toons are memoriziong spells.
can you snip me specifically your... i dunno, cleric or mage or shaman's settings tab as well as their current spell gems?
I will check what you have said and get back to you one way or the other. I had been using a few of them with buffbot macro but, I have never had this issue before so I am not sure what's going on....let me check all of what you said and I will let you know if anything changes, ***UPDATE: Invis was the problem ...thanks again.
- Status