Question - KA and MQ2Melee

[Dobs2017]

Once combat is initiated with a fear dragon, my melee stick to the dragon, however, once feared, they do not return.

Is there a setting in KA or MQ2Melee that I can alter so they run back and continue to fight the dragon?

[Melee]
AssistAt=98
MeleeOn=1
FaceMobOn=1
MeleeDistance=75
StickHow=snaproll
AutoFireOn=0
UseMQ2Melee=1

Is MeleeDistance the problem? If they go outside of 75 do they not return?

At the moment I use:

"/bcaa //nav target" to run them back

However, this gets a little messy with healers.

Any assistance would be greatly appreciated.

 

[Many_Whelps]

you pretty much got it. gonna have to nav your characters back to the mob. MeleeDistance will control the range at which they engage a mob, but you would not want that to large when you're fighting something that doesn't fear because they will then run out to engage pulled mobs before they're back at a proper camp.

 

[Sidien]

You can set up an eqbc channel for just your melee character, to avoid the healers/ranged dps also sticking when you issue your command.

On the melee chars, do:
/bccmd channels melee

Then your command to reposition after fear would be:
/bct melee //nav target

 

[Dobs2017]

Thank you for the replies.