Problem - Ignore

[bigdogs175]

I have searched and see the tons of ways to add stuff to ignore . But my ini or something keeps adding stuff to ignore , I target /addpull and next time out , it ignores it again ..
Thanks

 

[Sluggo77]

I think you have to remove it from the ignore list.
Not sure what the /command would be. But you could always go to the ini and delete that mob from the ignore list.

 

[dreamflux]

There is a temp ignore that gets set as well based on PC radius, off mesh, etc. It can be tough.

 

[Sluggo77]

I have searched and see the tons of ways to add stuff to ignore . But my ini or something keeps adding stuff to ignore , I target /addpull and next time out , it ignores it again ..
Thanks

What are you using?
KA, MA, CWTN?

 

[bigdogs175]

KA

 

[Sluggo77]

As far as I can find, go to ini and delete the mob from ignore list if it’s on there. Then check and make sure it’s in your pull radius, and check your pull zradius as well. If it’s on a hill or in a valley..etc it will ignore it if it’s above or below your zradius.
Could also be a pathing issue with mq2nav, if there is to much in the way or an area mesh reads as impassable.

 

[AmericanNero]

What version of KA are you using? At one time it would add mobs to the permanent ignore list. The newest version does not do that.

 

[ctaylor22]

You have to manually edit the kissassist_info.ini file to remove mobs from the list. The dynamic ignore list gets reset every 5 minutes.