Request - How to pull some certain mobs

[eqtrader63]

Hi,

what i want to do is... I want to pull just 6 certain Mobs in a Zone.. then wait for respawn and pull them again.

I tried to do that by mob id but it didn't work.

Is that possible at all?

Thx in advance for your answers
eqtrader63

 

[nyghteyes]

If they are all over the zone and not specifically in 1 camp. You would need to create a zone mesh with Mq2nav and the mesh generator then create paths to run. There are guides for this sorta thing but you may need to do some more searching to learn what you need. Start HERE

Looks like there was a post about the same thing and more has been answered THERE

 

[Meistro]

Are they 6 specific mobs in one location?
Are they the only mobs with that/those names?

If they are located in a smallish are that you can pull from one camp, and are using KissAssist, you can add their names to the MobsToPull list, adjust your pull radius to make sure al the mobs are in radius, and go to town.

If NOT all in a close area but not spread TOO much and have low chance of agro from other mobs you could also use KA with AdvPath, creating a path to each mob to be pulled.

MobsToPull listing (also has MobsToIgnore, MobsToBurn, and MezImmune) is found in your MQ2/Release/Macro folder in the kissassist_info.ini look for the zone in which you are hunting said mobs and add their name(s) to the pertinent line. Note: last time I used this list, it did ignore everything other than the mobs on the MobsToPull list, but that has been awhile, it may not, you may need to ad the name(s) of other mobs to the MobsToIgnore list if it wants to pull them.

If you are looking at pulling THIS Xnamed mob and THAT xnamed mob while ignoreing the 4 xnamed mobs just inbetween, you might be asking for more than a simple macro could do. Because I believe spawn id's can change even if the names do not, making that a bit unreliable