Question - bard pulling

[Huttont1]

I want to set it up to where I can have my bard pull for me and I manually to a point play another toon is there a good way to do that ???

 

[Forgotmyinfo]

In your bards ini file change assist to puller. Then if you want chain pulls edit that in the ini as well

 

[Huttont1]

Kk so if I wanna use autobard wont work for that will it

 

[LamahHerder]

Yes, run your bard with kissassist mode puller
The other toons can run either kissassist or autowar/cleric

The toon you are playing can run kissassist mode manual

 

[BrianGragg]

Kk so if I wanna use autobard wont work for that will it

Autobard no for pulling. You can still use autowar or autocleric.

Another option I do is leave my ini set to assist and manually issue the puller command when starting the macro. /Mac kissassist puller

This allows me to not accidentally start a toon with kiss and he run off to pull when I'm not ready. If I accidentally start it, he will be in assist mode and no harm done. If I want him to pull I just start the Mac with puller at the end and he starts pulling.


Sent from my iPhone using Tapatalk

 

[Navycook2011]

i cannot get my bard to go running off and pull, anyway to switch it from Line of Sight?

- - - Updated - - -

i cannot get my bard to go running off and pull, anyway to switch it from Line of Sight?

 

[EQbackagain]

Use mq2nav

 

[Sum1]

i cannot get my bard to go running off and pull, anyway to switch it from Line of Sight?

- - - Updated - - -

i cannot get my bard to go running off and pull, anyway to switch it from Line of Sight?

I'm in the Navy!

So to pull intelligently (and without line of sight), you have to use MQ2Nav (best, usually) or MQ2advpath (second best). For MQ2Nav make sure it's loaded (in game, type "/plugin MQ2Nav") and you need a mesh for the zone. There are guides here on how to use the Meshgenerator to make meshes for MQ2Nav.

Once you've built AND saved the mesh, it *should* auto load the zone's mesh (if you're already in zone). If it doesn't just type "/nav reload" and it will reload the mesh.

Start kiss and watch your toons! Sometimes nav will mess up ... I've had issues in a lot of zones (eastern side of Lcea is one example), and it gets more complicated and more prone to messing up when the zone gets more complicated (I haven't even tried it in water zones), but it's awesome if you can tweak the settings to suit your purposes!

Good luck!