Question - Ranger Not Activating Auto Fire On

[KS1980]

Version of KissAssist.mac?

12

When did your problem start?

after 64bit patch

Character Role?

1. Assist

What class is having this issue?

1. Ranger

How often does this issue occur?

Always

Can you reproduce the issue?

yes

Hello,

Before the 64bit Patch i was able to set my ranger at a fair distance and he would Autofire automatically. After the Patch the ranger will just try to actually use melee instead of autofire.
Settings are as follows:

[Melee]
AssistAt=99
MeleeOn=0
FaceMobOn=1
MeleeDistance=100
StickHow=45% moveback
AutoFireOn=1
UseMQ2Melee=1
TargetSwitchingOn=0


Question: Did something change or is there something im missing? my .ini file has not changed. If Melee0n=1 he will melee which is just fine. but on autofireon=1 and Meleeon=0 he will just turn melee on and i get the message your target is too far away although my distance from the target is roughly around 40-50. Ive tried adjusting the distance but still having the same issues.

Thanks

 

[VorpalChicken]

have a look at my ini for a 115 ranger, and see if that works for you, it's meant to stay around 35 feet away from the target to allow for the use of your jolts which will hit in melee, but allow you to be using your bow.

Bow Ranger, 115 ToV, The Ranger must not be susceptible to emotions such as anxiety and remorse

This is a special ini and requires the use of a kissmycmds.inc, which will be included below the main KissAssist ini. This ini will allow your ranger to move approximately 35 feet from the target and rain down spikey death, be warned it's not...

www.redguides.com

 

[KS1980]

thanks,

i think i see the problem or i belive i see it. it turns on range attack autofire on, then turns autofire off then goes into melee mode at which point i get target is too far away get closer .

 

[Faazed]

Just turn off MQ2Melee you have it set to 1. I haven't touched my ranger file and it works fine.