Since the patch on 12/12 I have been having issues with pulling in the new OT zone. Every time the puller hits a sarnak trap it messes up pulling, and appears it can?t find mobs to pull. I have played with it and it can last up to 10 minutes just searching for targets. If I re-run KA or pull with another toon it fixes the issue. I am using MQ2Nav to pull, but even without MQ2NAV I see the same issue.
-
You've discovered RedGuides, an EverQuest multi-boxing and scripting community 🧙♀️⚙️. We want you to play several EQ characters at once, come join us and say hello! 👋
Problem - Pulling issue after sarnak trap in RoS OT
- Thread starter Medic181
- Start date
- Joined
- Nov 30, 2016
- RedCents
- 40¢
Try the following, as I too had this issue in OT.
1. Try to position your group offset to the trap.
2. Open up the kissassistinfo file and enter MobsToIgnore=a sarnak trap,
This will prevent your puller from having to try to pull the trap. if you find that your puller is en route to a monster and hitting the trap, easly trrposdition your group until you find that sweet spot.
Hope this helps
1. Try to position your group offset to the trap.
2. Open up the kissassistinfo file and enter MobsToIgnore=a sarnak trap,
This will prevent your puller from having to try to pull the trap. if you find that your puller is en route to a monster and hitting the trap, easly trrposdition your group until you find that sweet spot.
Hope this helps
Nothing is showing up in xtarget, it like the trap causes an error since MQ2 can't move to the correct destination.
I have already added them to ignore and tried in many locations, sometimes when following the mob to pull my bard hits one of the traps still.
I have already added them to ignore and tried in many locations, sometimes when following the mob to pull my bard hits one of the traps still.
- Joined
- Nov 30, 2016
- RedCents
- 40¢
the only thing I can suggest then is that you create a point in the mesh and remove the tile so when mq2nav is used it will avoif the area of the trap. The trap doesn't show up on the ctarget and is judt there to be an annoyance. so just try to remove tiles where the trap is on the mesh and see if that helps
If the traps are stationary and always in the same location, what islandgirl suggested would be a good idea.. But just remember the pull routine switches from mq2nav to moveutils in some situations, so it will never be 100% full proof.