Question - pullignores.ini

[zaphod]

In regards to the pullignores.ini, I notice everything says Ignore=|a quest npc| to ignore the pull on that npc, conversely, would Pull=|a mob name| only pull that specific mob and ignore all others in zone? trying to selectively hunt a short list for lower level TS matts.

 

[wired420]

No clue what pullignores.ini is used for, but while you wait for an answer figured I'd throw in a suggestion. I use this for farming TS mats, and I just use the built in commands listed on the page to add ignores/pulls.

Utility - Pocketfarm.mac

2019 ESA Winner Welcome to Pocketfarm.mac. NEW FEATURES IN VERSION 2.0 Pocketfarm.mac now have camp mode!!!! Start it using /mac pocketfarm camp It will then create a nice camp with your radius, if you leave out the radius...

www.redguides.com

 

[zaphod]

It seems like it wouldn't be too difficult to add in the ignore mobs one by one in a given radius. I will give that a shot, thanks

 

[Sic]

pull ignores is what the cwtn plugins use to ignore mobs


there is no "only pull" in the ini