Question - Puller tank not returning to camp?

[FV_Remnant]

Anyone have trouble puller tanking as a warrior? I like to use melee to pull but often he?ll just sit at the target he agros and just melee it rather than return to camp. Any advice would be helpful.

 

[kaen01]

what is meleedistance=, and what is campradius=?

 

[Darb]

is /camphere on?

 

[daeomonio]

I have the same pb. when my tank start melee it stay in fight. I do pause on Kissassist but same, impossible to stop melee. I must pause and then target me to be abble to move. Till i stoped Kissassist i think it s an other plugin that make pb but dont know witch one, ant idea ? here my list of plug in :
MQ2advPath
MQ2Autoaccept
MQ2autoforage
MQ2Bzsrch
MQ2cast
MQ2 ChatWnd
MQ2Mcheck
MQ2Lrc
MQ2Melee
MQ2Move Utils
MQ2Posse
MQ2 rez
MQ2 Spawnmaster

 

[hellfyre]

what is meleedistance=, and what is campradius=?

Needed information. Try to pull with throw stone and see if that helps

 

[daeomonio]

MeleeDistance=75
CampRadius=50

 

[eqtrader74]

MQ2Melee plugin is what locks on the target and tries to stay in melee range if you start attacking. It will do that even if you don't have Kiss running. Type "/melee" to see or change settings if you want. "/melee save" if you want to make any changes permanent. It also saves those in your main MQ2 ini file, not your KA one.

"/plugin mq2melee unload" will turn it off, "/plugin mq2melee" will turn it on.

FV_Rem - Check your returntocamp setting in the tanks ini too. The /camphere can engage/disable the loc it's using. If I have it off, my tank will fight where he gets aggro. I've seen mq2melee mess up my Pullertank in a similar way if I'm trying to run KA and manually help, which is my fault, not KA's heh.

 

[daeomonio]

so i have to stop MQ2melee and mu tank will pull back to camp ? thx for your help

 

[ctaylor22]

ReturnToCamp=1?

 

[daeomonio]

yes return to camp =1

 

[saar]

need to use /stick=0 then /melee save and should allow you to pull and return to camp. or invest in a bow and arrows or daggers. What is happening is your pulling and to close to the mob and the plugin mq2melee says attack on (to pull the mob) but i am within x range so lets stick to its face which is why it just stays out there.

 

[saar]

almost need to add a variable to kiss for puller and pullertank for /stick=0 so you dont get repeats of this issue.

 

[hellfyre]

I still say use an arrow or throw stone

 

[saar]

yes i always pull with an arrow or gimp pulling using harmonious precision and targeting mobs within a 300 radius around me and not move.....judt cast a heal on the warrior and watch the magic.