Problem - My "Camp On" hotkey is beeping 4-5 times

[fadedreplays]

This only started happening about a week or so ago. I got back on after my lovely week long vacation from DPG. Whenever i hit my Camp On hot key i get 4 loud obnoxious beeps. I can't figure out how to stop it. Mine is setup a little different because im not driving my tank.

But I'm using CWTN plugins for my whole party.

My "Camp On" is coded as follows:

/bcga //camphere on
/cwtn mode 1
/bct ToonName //pal mode 4
/bct ToonName //pal resetcamp

I have it set that way so I don't have to drive my tank.

I can't for the life of my figure out what's beeping. Its not beep on tell, that is off.

 

[Sic]

Each resource on RG has an Overview / Discussion Thread and either a link to their wiki or tabs with FAQ, Commands, Etc.
Please make sure to post in the respective discussion thread, and check the FAQ/Commands/Wiki for information before posting.

Please see >>> Getting Started with CWTN plugins! (Movement, UI Window, Clickies, Pulling, ETC) Check Here First! <<<

If it is the cwtn beeping, it is likely due to trying to set a camp in an area you don't have a mesh for, which would then kick you to assist mode, beep, and tell you all about it

Since you're not using kiss on anyone, you can also remove the camphere on portion of the hotkey

 

[fadedreplays]

Each resource on RG has an Overview / Discussion Thread and either a link to their wiki or tabs with FAQ, Commands, Etc.
Please make sure to post in the respective discussion thread, and check the FAQ/Commands/Wiki for information before posting.

Please see >>> Getting Started with CWTN plugins! (Movement, UI Window, Clickies, Pulling, ETC) Check Here First! <<<

If it is the cwtn beeping, it is likely due to trying to set a camp in an area you don't have a mesh for, which would then kick you to assist mode, beep, and tell you all about it

Since you're not using kiss on anyone, you can also remove the camphere on portion of the hotkey

Sic TYSM, i checked output and it says "You have a set camp but are OFF MESH". I was sure i had all the Nav meshes but i guess i need to update.