Problem - MQ2HUD not displaying for me

[Maha]

I had HUD working somewhat before this last update 12/14 I think it was. Using a small sample that someone had posted. I have the F-11 showing the net status. and of course f-11 turns it on and off...but the mqhud doesn't display at all now. I've downloaded a couple other ini files that I've found here on RG but haven't found anything that works since the update. Someone please point me to a troubleshooting routine that will help me figure it out plz. I don't have much hair left at all now...just kind of 'round the edges.

Thanks for any and all help.

Maha

 

[Warl0ck45]

make sure the plugin is actually loaded

if you put stuff in the "Elements" section you can try "/defaulthud"

or if you made another section you can try "/load nameofsection"

you could also potentially have a corrupted file there, could try moving/deleting the DLL file and redownloading it

 

[Maha]

Ok...I'll try redownloading the DLL. Thanks

- - - Updated - - -

Yes...it is loading. I typed /plugins mq2hud and it says loaded. But nothing shows at all. I'll keep poking around on it.

- - - Updated - - -

I haven't read it anywhere, but is there certain screen resolutions that might be keeping it from working? I use 1920 by 1080 and in windowed mode. Now I'm looking at the commands and structuring trying to find a clue here. It's rather frustrating to say the least. Any help here is greatly appreciated.
Thanks...
Maha

 

[Maskoi]

Check your mq2hud.ini file make sure its not empty.