Max radius not working. (1 Viewer)

[Adamthebob]

Could someone fix my puller.mac please? It is pulling mobs outside of it's max radius for some stupid reason...

 

[armysoldier]

/declare RV_MaxRadius int outer 5

raises a flag to me... since the macro starts checking for mobs at 100 to max radius .. in 5 increments...


change this to a number above 100


I think you changed your values on stuff tooo low




ARMY

 

[Adamthebob]

I just did that to make sure that it was broken...but I do use some low numbers some time.

Is there a way to have it set up to use low or high numbers?

 

[armysoldier]

in the get target sub

/for RV_CurrentRadius 100 to ${RV_MaxRadius} step 5
is the radius the macro is looking for mobs... you could change the 100 to something lower.

ARMY

 

[Adamthebob]

Sweet! Thanks