Request - Kissassist pulling locations

[redhero1000]

Is it currently feasible with anything in the Redguides arsenal to emulate (or if someone is eager actually to create) something like this while using Kissassist:

(kissassist character .ini idea below)

PULL_LOC1=-120.02, 44.08, .025
PULL_LOC2=-400.07, 23.77, .093
PULL_LOC3=27.02, 33.94, 40.021

Where the puller would do the following:

Attempt to perpetually loop through the listed PULL_LOCx values in the puller's .ini file, only swapping to a new PULL_LOC value after the current PULL_LOC value has been attained.

Ideally, this could be toggled on and off to work with the pullers defined PullArcWidth value.

 

[Sic]

kiss has this option in your KissAssist_Info.ini

 

[redhero1000]

I don't understand, from what I'm reading in the guide it says:

https://www.redguides.com/docs/projects/kissassist/
PullLocs 1-5 are used to EXCLUDE mobs in an area from being pulled. Think of it as MobsToIgnore, but using a physical area.

I'm seeking to have my puller go down 2 differing tunnels for mobs that fall outside the PullArcWidth setting.

https://www.redguides.com/docs/projects/kissassist/
Are you referring to the "PullPath=Place holder for path file. Not yet implemented" setting?

 

[Sic]

I don't understand, from what I'm reading in the guide it says:

https://www.redguides.com/docs/projects/kissassist/
PullLocs 1-5 are used to EXCLUDE mobs in an area from being pulled. Think of it as MobsToIgnore, but using a physical area.

I'm seeking to have my puller go down 2 differing tunnels for mobs that fall outside the PullArcWidth setting.

https://www.redguides.com/docs/projects/kissassist/
Are you referring to the "PullPath=Place holder for path file. Not yet implemented" setting?

yup looks like you're correct - i thought they had implemented the custom path stuff for hunter mode ages ago

 

[Maskoi]

KissAssist supports multipaths using MQ2Advpath.
@ctaylor22 would have to explain it for you though it was some seriously weird code and I never used that feature.