Question - Kissassist (Do not Pull list?)

[Klixor]

Is it possible to add mobs to Do not Pull list? I have seen MQ pop up a message that says Mob has been added to do not pull list but it does not work, I would also like to manually add mobs if possible to avoid issues with specific pulls.

 

[B_I_G__D_A_D_D_Y]

Is it possible to add mobs to Do not Pull list? I have seen MQ pop up a message that says Mob has been added to do not pull list but it does not work, I would also like to manually add mobs if possible to avoid issues with specific pulls.

As @Sifter228 posted there is a file to place this kind of mob info. Keep in mind that the entries in this file are NOT read in real time. If you add a mob to the list it will not take effect until the next time you start the KissAssist macro.

 

[Klixor]

Does this add a specific mob spawn to do not pull list or every mob Named the same once added?

 

[ctaylor22]

The message you get when kiss adds a mob to the ignore list, when kiss is trying to pull and can't for some reason. That list is a temp list that is cleared every 5 minutes.

If you want to add a specific target/mob. You will have to have the mob on target and use this command:

/addignore ${Target.ID} 1

This adds the mobs ID to a list to ignore. This list gets reset if the macro is ended and you will have to add the mob again each time the macro is started.

 

[DriveCrash]

You can also add mobs to the ignore list in the kissassist_info.ini file in the macro folder. The list is broken into zones, but zones are only added after you've been there. Under MobsToIgnore you can add 25 by name. I've not tested it enough to know if one of those mobs agro's into the camp if they will engage or ignore it, but I suspect they will engage.