Question - Enchanter stun macro for phinnigel

[thegreat]

I have seen enchanters using a stun loop macro on phinny for the AOE groups. How is this being done without MQ? Thanks

 

[rhiza]

there are many ways it can be done.

firstly, you sure they aren't doing it manually? its not like its hard or challenging.

can be done with macro software on a keyboard. the Logitech software can do it no trouble. just keypress 1 > delay > keypress 2 > delay > keypress 3 > delay then loop.

can also be done with software such as hotkeynet which can have macros for keypresses AND broadcast to other PC's

 

[thegreat]

Thanks for your reply ! The people I see doing it are pulling while stunning and the macro is going after the mobs are dead so I am sure they are running some sort of script.

I am aware of Logitech keyboards but don't have one

I was mainly wondering if there was a way to run it through the EQ hotkeys using /pause and /cast

 

[Warl0ck45]

heck you can set up hotkeys for casting

/pause o35, /cast 1
/pause 034, /cast 2
/pause 037, /cast 3

just takes trial an error to get the pause right for the spell, focus, and PC lag

 

[thegreat]

heck you can set up hotkeys for casting

/pause o35, /cast 1
/pause 034, /cast 2
/pause 037, /cast 3

just takes trial an error to get the pause right for the spell, focus, and PC lag

ya i am looking to make this loop on its own after the last cast or if that is even possible.

 

[nyghteyes]

EQ's native macro will not loop, you will need extra software. Logitechs is free but I think you need the hardware to go with it. All of the G-series pads/keyboards use this software.

I use G510 and wouldn't trade it for any other KB, though how I use it is very lacking compared to what it can do.

 

[Warl0ck45]

I was mostly getting at "MQ is not used on Phinny, and that behavior can be accomplished with just ingame EQ macros"