Recent content by Adonhiram

Works like a charm now, thank you !. Fyi, Sic said "need to be single line" which lead to some confusion.

Oh you can be sure I know exactly what /pet focus does :) Thank you kindly for your advise.

/pet focus jus won't work either if I modify my Zoned.cfg like this, except in Nexus. I guess the issue is not solvable - it is not critical though, I can manually press /pet focus after I zone, won't kill me... Thanks everyone

I have raised the delay to 20. It works only when I zone to the Nexus (upon zoning /pet focus is toggled to on), but it doesn't work when I zone into other zones. Any ideas perhaps ? I admit I am perplex. /hidecorpse looted and /end work each time though.

Ok understood;, thx Right now it doesn't work, I am raising the timed value to 15 to see if that is the issue. As for putting /end at the the end of the list of instructions, it doesn't seem to raise issues as far as I could see.

Thank you Sic, do I need to put the "pause" on its own line ? Will try that and remove /docommand for /pet focus. Sure, I'll test and will report here, always fun to experiment :) Will test this and report :

Hello guys, I have discovered recently (thanks to you all !) how to use the Zoned.cfg file to give instructions to be executed on zoning. As shown in my Zoned.cfg file, the first and the second command work perfectly, every time I zone, any active macro ends and the /hidecorpse looted command...

So, it works ! Thank you all

I already had a zoned.cfg file in my config folder and Notepad+ can edit it. Now it has two lines (the first line was already there) :

Thank you. If I opt for this solution, would the correct syntax be : /if (${Me.Zoning}) /end And, sorry to ask what might be obvious, but where do I put this line, in which file ?

Thanks for your replies, very useful stuff :) Sounds very easy to do, thanks. Given you can run only one macro at a time per character, it doesn't bother me. EDIT : how do I create a file with *.cfg extension, can Notepad+ handle that as *.txt and *.ini files ?

Hello guys, Just a simple question. Is there a way to have a macro /end itself upon zoning without issuing manually an /end command ? Thanks if you know the answer.

Understood, thank you for the explanation

Err how do i give more than 1 cent ? When I click the "c" symbol it gives you guys only 1 cent and I don't see how to increase the number... sorry these forums are sometimes a bit complicated to have an overview :)

Thank you guys !