Question - How do I enter a multiline command into MQ2MyButtons? Or, make a multiline command a single line? (1 Viewer)

[1Fungame]

I would like to use MQ2MyButtons for @Sic Hotkeys - so I can have the same control keys on all my toons. I'm having trouble figuring out the syntax. I have looked through the discussion's on both threads, but I'm not seeing an example that helps me.

How would I make the Camp Off Key (for example) in MyButtons (since it only gives a single line for commands)?

/bcga //returntocamp 0
/noparse /bcga //docommand /${Me.Class.ShortName} mode 0
/noparse /bcga //if (${Me.Class.ShortName.Equal[CLR]}) /dismount
/bcga //chaseoff

I think, if I understood how to do one, that I could figure out the rest.

Thanks!

 

[ArcaneProphet]

I've only just learned this, but you could try:

/multiline ; /bcga //returntocamp 0; /noparse /bcga //docommand /${Me.Class.ShortName} mode 0; /noparse /bcga //if (${Me.Class.ShortName.Equal[CLR]}) /dismount; /bcga //chaseoff

edit: make sure after /multiline there is a space semicolon then space.

 

[1Fungame]

Thanks I will try that. So, after the "/multiline ; " then it is just the rest of the code with a "; " after each line (or command) if two commands were on the same line?

 

[Amarth]

yes, but make sure you double the // for mq2eqbc following

 

[Amarth]

yes, but make sure you double the // for mq2eqbc following

But keep in mind that there is a character limit per line, as i recall.